Oceanled x-series x4 ultra white 012301w

ABOVE WATER MOUNTING
The X Series can also be used as an exterior light for your cockpit, deck or trailer..

COMPACT AND SIMPLE DESIGN
Made from a chemically resistant optical polymer with a built in driver, there is a lot packed into this compact light.

SIMPLE TO INSTALL
Installation needs only a small, 12.5mm hole in the hull to feed the cable through and 4 screws to hold in place. No bonding required.

EASY TO CLEAN
Thanks to its Tritonium coating, a simple wipe of the lens removes any underwater growth, saving hours of scrubbing each time you use your boat.

FISH-STROBE MODE
Exceptionally bright, randomised strobing of the light is proven to attract more fish and catch more bait.

ACTIVE THERMAL CONTROL
ATC prevents overheating. In the event of overheating the ATC system will reduce the LED power level in order to protect the LEDs, or in extreme cases, turn off the fixture completely

FEATURES:
- Compact and simple design
- Simple to install
- Easy to clean
- Fish-Strobe Mode
- Active Thermal Control

BOX CONTENTS:
- X-Series LED Light and Cable
- In-line Fuse Kit
- Mounting Screws
- Quick Install Guide

Technical:
- Lumens: 1450
- Fixture Lumens: 1150
- Typical LED life expectancy: 40,000+ Hours
- Minimum-Maximum operating voltage DC: 9-32V DC
- Current / Amp draw (DC): 12V DC 0.8A 24V DC 0.4A
- Approx. light penetration (avg. water quality): 20’ (6m)
- Approx. Light penetration (perfect water quality): up to 45’ (13+m)
- Driver type: Internal, Reverse Polarity Protected

Mounting Recommendations:
- Boat size: up to 30’ (9m)
- Transom / Hull spacing: 2-3’ (0.5-1m)
- Transom quantity: 2-4
- Installation depth (to top of fixture): 4-8” (10-20cm)

Physical:
- Total weight: 350g (0.78lbs)
- Extension cable length (standard): 9.84’ (3m)
- Hole cut-out for cable entry:0.5” (12.5mm)
- Material: Chemically resistant optical polymer